 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
INJECTION PUMP DRIVE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
13.
Injection pump
Front bearing (2)
Using arbor press, put on.
drive shaft (1)
14.
Front crankcase
Rear bearing (4)
a. Using 5 5/8-inch (14.287-cm) adapter
cover (3)
from bearing remover set, put bearing
on installer.
b. Tap into cover (3) using plastic-face
hammer until adapter is flush against
cover (3).
INSTALLATION
15
Injection pump
Put in.
drive shaft (1)
16.
Injection pump
Snapring (5)
Put on using snapring pl iers.
drive shaft (1)
17
Injection pump
a Line up with camshaft gear (7), and
drive gear (6)
put on.
b. Turn drive shaft (1) until holes line
up with drive gear (6).
c. Tap on using plastic-face hammer.
18
Three new lock-
Screw in, and tighten to 20-25 ft-lb
washers (8) and
(27-34 N m) of torque using 1/2-inch
screws (9)
socket and torque wrench with 1/2-inch
drive.
19.
Injection pump
Injection pump
Put on.
drive shaft (1)
drive hub (10)
20
Two grip springs
Put on.
(11) and washer (12)
21.
Injection pump
Nut (13)
Screw on part way.
drive hub (10)
ADJUSTMENT
22.
Engine
Left side cylinder
Remove (page 2-180).
head cover
2-328
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals