DISASSEMBLY - CONTINUED - TM-9-2320-269-34-10311

TM 9-2320-269-34-1

FUEL INJECTION PUMP - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

DISASSEMBLY - CONTINUED

76. Fuel injection

Bleeder bushing (2)

Using 11-mm open-end wrench, unscrew

pump (1)

and take out.

77.

Oil inlet bushing

Using 19-mm open-end wrench,

(3) and gasket (4)

unscrew and take out.

Get rid of gasket (4).

78.

Pump fitting (5)

Using 19-mm open-end wrench,

and gasket (6)

unscrew and take out.

Get rid of gasket (6).

79.

Closing cap (7)

Using 10-mm hex key bit and hinged handle,

with 3/8-inch drive, unscrew and take out.

80.

Fuel injection

Take out of holding fixture.

pump (1)

CLEANING

NOTE

For more information on how to clean parts, go to General Maintenance Instructions (page 2-46).

Many of the fuel injection pump parts are machined to fit. clean all parts and assemblies separately, and keep fall

assemblies together to insure proper placement and operation.

81. Fuel Injection

All gasket surfaces

Using putty knife, clean away old gasket

pump (1)

material.

82.

All threaded parts

Using wire brush, clean away old sealing

compound.

WARNING

Diesel fumes can explode. If welding of fuel tank is necessary, always work in well-ventilated area, and keep tank

full of water at all times. Failure to follow these precautions could cause serious injury or death.

83.

All parts

Wash in clean No. 2 diesel fuel.

Using clean rags, wipe dry all parts

except machined parts.

84.

All bearings

Clean (TM 9-214).

2-294