|
|
TM 9-2320-269-34-1
SWIRL DESTROYER - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
27.
Intake manifold
Two setscrews (3)
a. Using 7/16-inch open-end wrench,
(1) and shaft
and two collars (4)
loosen screws (3).
assembly (2)
b. Move shaft (2) and use 0.005-inch
(0.12-mm) thickness gage to fix cor-
rect clearance between plate (5) and
manifold (1).
c. Adjust collars (4) against manifold
(1), allowing shaft (2) to turn freely
while still maintaining 0.005 inch
(0.12 mm) clearance between plate
(5) and manifold (1).
28.
Two actuating
Four nuts (7)
Screw on, leaving same number of exposed
rods (6)
threads as recorded in step 15a.
29.
Four ball joints
Screw on to nut (7).
(8) and (9)
30.
Four nuts (7) and
Tighten using 7116-inch and 3 /8-inch
ball joints (8)
open-end wrenches.
and (9)
31.
Lever (10)
Two ball joints (9)Put in position.
and washers (11)
32.
Lever (10) and two
Two new self-
Screw on, and tighten using 3/8-inch
ball joints (9)
locking nuts (12)
and 7/16-inch open-end wrenches.
33.
Cable bracket (13)
Two split washers
Put through.
(14) and control
rod (15)
34.
Control rod (15)
Nut (16)
Screw on, leaving same number of exposed
threads as recorded in step 10a.
35.
Yoke (17)
Screw on to nut (16).
36.
Nut (16)
Using 3/8-inch open-end wrench, tighten.
37.
Lever (10)
Yoke (17) and two
Put in position.
split washers (18)
38.
Lever (10) and
Pin (19
)Put through.
yoke (17)
2-242
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |