 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
PISTONS AND CONNECTING RODS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
15.
Two connecting
Two washers (3)
a.
Using 11/16-inch socket
and torque
rod screws (10)
and nuts (2)
wrench with 1/2-inch drive, screw
on
until snug. Tighten to 55 ft-lb
(75 N m) of torque.
b.
Using same socket and torque wrench,
turn each nut an additional one-sixth
turn (one flat on nut).
c.
Using 11/16-inch socket and ratchet
handle with 1/2-inch drive, unscrew
and take off.
d.
Get rid of washers (3) and nuts (2).
16.
Connecting rod (4)
Connecting rod bear- a.
Take off.
and crankshaft (5)
ing cap (1) with
Plastic tape will
be stuck to either
lower bearing
bearing shell or crankshaft
shell (6)
journal.
b.
Using markings on plastic gage
envelope, measure width of plastic gage
strip at its widest point (page 2-46).
TA237998
2-145
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals