COUPLE

TM 9-2320-269-34-1

ENGINE ASSEMBLY - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

COUPLE

Be careful when lifting and mating transmission to engine. Torque converter can slide out of

transmission housing and fall, causing injury to you and damage to equipment.

62.

Flywheel housing (1)

New gasket (2) and

With transmission supported with hoist and

transmission (3)

engine assembly mounted in engine over-

haul stand, move onto housing (1).

Make sure torque converter studs

mate with holes in flywheel.

63.

Transmission (3)

Four washers (4) and

At 9, 11, 1, and 3 o'clock positions, screw

screws (5)

in and tighten using 9116-inch socket and

ratchet handle with 1/2-inch drive.

64.

Eight washers (6)

Screw in, and tighten using 9/16-inch soc-

and screws (7)

ket, 6-inch extension, and ratchet handle

with 1/2-inch drive.

65.

Twelve screws

Using 9/16-inch socket, 6-inch extension,

(5) and (7)

and torque wrench with 1/2-inch drive,

tighten all screws (5) and (7) to 26 - 32

ft-lb (35 - 43 N m).

66.

Crankshaft (8)

Crankshaft pulley

Using 2-inch socket and ratchet handle

nut (9)

with 3/4-inch drive, have an assistant

turn nut (9) which will rotate the fly-

wheel (10) so that torque converter studs

can be seen through housing (1) cover

hole.

67.

Flywheel (10)

Six nuts (11)

a. Screw in, and tighten using 9/16-

inch deep well socket and ratchet

handle with 1/2-inch drive.

b. Using 9/16-inch deep well socket and

torque wrench with 112-inch drive,

tighten to 33 - 40 ft-lb (45 - 54 N m)

of torque.

68.

Flywheel housing (1)

Hand hole

Place in position.

cover (12)

2-68