 |
|||
|
|
|||
|
Page Title:
EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS |
|
||
| ||||||||||
|
|
 TM 9-1375-213-12-3
TO 11A20-15-1
b. Column 2,
Component/Assembly,
sets (not individual tools) and special tools,
Column 2 contains the names of components,
TMDE, and support equipment required to per-
assemblies, subassemblies, and modules for
form the designated function.
which maintenance is authorized,
This column
f . Column 6, Remarks,
c. Column 3, Maintenance Function.
shall, when applicable, contain a lettercode, in'
Column 3 lists the functions to be performed on
alphabetic order, which shall be keyed to the
the item listed in Column 2. (For detailed expla-
remarks contained in section IV.
nation of these functions, see paragraph C-2
"Maintenance Functions" on page C-l,)
C-4. EXPLANATION OF COLUMNS IN
TOOL AND TEST EQUIPMENT
d. Column 4, Maintenance Level. Column
REQUIREMENTS, SECTION 111
4 specifies, by the listing of a work time figure
in the appropriate subcolumn(s), the level of
a. Column 1, Reference Code. The tools
maintenance authorized to perform the func-
and test equipment reference code correlates
tion listed in column 3. This figure represents
with a code used in the MAC, section II, column
the active time required in hours to perform
5.
that maintenance function at the indicated
level of maintenance. If the number of complex-
b. Column 2, Maintenance Level. The low-
ity of the tasks within the listed maintenance
est level of maintenance authorized to use the
function vary at different maintenance levels,
tool or test equipment.
appropriate work time figures will be shown for
each level. The work time figure represents the
c . Column 3, Nomenclature. Name or
average time required to restore an item (assem-
identification of the tool or test equipment,
bly, subassembly, component, module, end item,
or system) to a serviceable condition under typi-
d. Column 4, National/NATO Stock
cal field operation conditions,
This time
Number. The national/NATO stock number of
includes preparation time, troubleshooting
the tool or test equipment.
time, and quality assurance/quality control
time in addition to the time required to per-
e. Column 5, Tool Number. The manufac-
form the specific tasks identified for the mainte-
turer's part number,
nance functions authorized in the maintenance
allocation chart. The symbol designations for
C-5. EXPLANATION OF COLUMNS IN
the various maintenance categories are as fol-
REMARKS, SECTION IV
lows:
C - Operator or crew
a. Column 1, Reference Code, The code
O - Unit maintenance
recorded in column 6, section II.
F - Direct support maintenance
H - General support maintenance
b. Column 2, Remarks. This column lists
D - Depot maintenance
information pertinent to the maintenance func-
tion being performed as indicated in the MAC,
e . Column 5, Tools and Equipment,
section II.
Column 5 specifies, by code, those common tool
C-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals