BALLISTICS DRIVE REMOVAL (CONT) - TM-9-1220-220-340058

TM 9-1220-220-34

4-4.

BALLISTICS DRIVE REMOVAL (CONT)

FRAME 1

Step

Procedure

Disconnect electrical connection (1) from elevation interference switch (2).

Using Phillips screwdriver, remove two screws (3) and two lockwashers (4) holding

bracket (5) to ballistics drive.

Remove bracket (5) and switch (2).

Using 7/16" box end wrench, remove one screw (6) and one lockwasher (7). Holding

clamp assembly (8) to cross shaft assembly (9).

NOTE

Clamp assembly (8) should remain in vehicle. Clamp

assembly (8) is not part of ballistics drive.

Remove clamp assembly (8) with limit stop attached.

GO TO FRAME 2

Para 4-4 Cont Vol II

4-4