QUICK RELEASE PIN (6)

NOTE

Perform step 7 only if either

retaining strap assembly has

5 QUICK RELEASE PIN (6). Install on

been removed.

chain (11).

One retaining strap assembly

6 QUICK RELEASE PIN (6) AND

will be installed approximately

CHAIN (11). Install on extractor fitting

1/4 in. (0.635 cm) from open

assembly (18) and secure with lock-

end of extractor fitting as-

washer (10) and screw (9).

sembly, and the other will be

installed approximately 2-1 /2

in. (6.350 cm) from the closed

end.

EXTRACTOR FITTING ASSEMBLY (18).

a. Wipe installation area with alcohol (item 4, app D).

b. Clean installation area with solvent (item 2, app D) and wipe off before

solvent dries.

c. Apply 1-in. (2.540-cm) wide strip of primer (item 7, app D) to installation

area, and allow to set up.

d. Apply 1-in. (2.540-cm) wide strip of adhesive (item 1, app D) to installa-

tion area.

RETAINING STRAP ASSEMBLY (4). Install and allow adhesive (item 1,

app D) to cure.

ALINEMENT SUPPORT (8). Install.

NOTE

Repeat step 7 before installing retaining strap assembly (3).

10 RETAINING STRAP ASSEMBLY (3). Install and allow adhesive (item 1, app

D) to cure.

TM 9-1025-212-23&P

3-5 Change 1