COLUMN ENTRIES USED IN TOOL AND TEST EQUIPMENT REQUIREMENTS

TM 5-6675-329-13 & P

detailed explanation of these functions, see paragraph B-2).

Column 4, Maintenance Level Column 4 specifies, by the listing of a work time figure in the appropriate

subcolumn(s), the lowest level of maintenance authorized to perform the function listed in column 3. This figure

represents the active time required to perform the maintenance function at the indicated level of maintenance. If the

number or complexity of the tasks within the listed maintenance function vary at different maintenance levels,

appropriate work time figures will be shown for each level. The number of man-hours specified by the work time figure

represents the average time required to restore an item (assembly, subassembly, component, module, end item, or

system) to a serviceable condition under typical field operating conditions. This time includes preparation time,

troubleshooting time and quality assurance/quality control time in addition to the time required to perform the specific

tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol designations

for the various maintenance levels are as follows:

C ............................................... Operator or crew

O............................................... Organization maintenance

F ............................................... Direct support maintenance

H ............................................... General support maintenance

D ............................................... Depot maintenance

Column 5, Tools and Equipment Column 5 specifies, by code, those common tool sets (not individual tools)

and special tools, tests and support equipment required to perform the designated function.

Column 6, Remarks This column shall contain a letter code in alphabetical order which shall be keyed to the

remarks contained in Section IV.

B-4. COLUMN ENTRIES USED IN TOOL AND TEST EQUIPMENT REQUIREMENTS

Column 1, Tool or Test Equipment Reference Code The tool and test equipment reference code correlates

with a maintenance function on the identified end item or component.

Column 2, Maintenance Level The lowest level of maintenance authorized to use the tool or test equipment.

Column 3, Nomenclature Name or identification of the tool or test equipment.

B-3