|
|
TM 5-6675-250-34
Table 2-1. Troubleshooting - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
g. Adjust the plunger extender so that the movable clutch half enters the caging cam clutch teeth
and bottoms out, without the clutch actuator arm moving in relation to the clutch actuator,
i.e., the clutch actuator arm and the clutch actuator shall not deflect at the pivot point.
switch is actuated 0.10 to 0.020 inch (.250 to .500 CM) from full extension of the solenoid
plunger.
i. Tighten switch mounting block screws.
2-75
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |