COLUMN ENTRIES USED IN THE MAC. - TM-5-6640-214-140138

TM 5-6640-214-14

g. Install. The act of emplacing, seating, or fixing into position an item, part, or module (component or assembly) in

a manner to allow the proper functioning of an equipment or system.

h. Replace. The act of substituting a serviceable like type part, subassembly or module (component or assembly)

for an unserviceable counterpart.

i. Repair. The application of maintenance services (inspect, test, service, adjust, align, calibrate, or replace) or

other maintenance actions (welding, grinding, riveting, straightening, facing, remachining, or resurfacing) to restore

serviceability to an item by correcting specific damage, fault, malfunction, or failure in a part, subassembly, module

(component or assembly), end item, or system.

j. Overhaul.

That maintenance effort (services/actions) necessary to restore an item to a completely

serviceable/operational condition as prescribed by maintenance standards (i.e.-, DMWR) in appropriate technical

publications. Overhaul is normally the highest degree of maintenance performed by the Army. Overhaul does not

normally return an item to like new condition.

k. Rebuild. Consists of those services/actions necessary for the restoration of unserviceable equipment to a like

new condition in accordance with original manufacturing standards. Rebuild is the highest degree of material

maintenance applied to Army equipment. The rebuild operation includes the act of returning to zero those age

measurements (hours/miles, etc.) considered in classifying Army equipments components.

B-3. COLUMN ENTRIES USED IN THE MAC.

a. Column 1, Group Number. Column 1 lists group numbers, the purpose of which is to identify components,

assemblies, subassemblies, and modules with the next higher assembly.

b. Column 2, Component/Assembly. Column 2 contains the names of components, assemblies, subassemblies,

and modules for which maintenance is authorized.

c. Column 3, Maintenance Functions. Column 3 lists the functions to be performed on the item listed in column 2.

(For detailed explanation of these functions, see paragraph B-2).

d. Column 4, Maintenance Level. Column 4 specifies, by the listing of a work time figure in the appropriate

subcolumn(s), the lowest level of maintenance authorized to perform the function listed in column 3. This figure

represents the active time required to perform the maintenance function at the indicated level of maintenance. If the

number or complexity of the tasks within the listed maintenance functions vary at different maintenance levels,

appropriate work time figures will be shown for each level. The number of man-hours specified by the work time figure

represents the average time required

B-2