STARPIN KEYPAD OPERATION (CON'T) - TM-5-6350-275-24-P0320

TM 5-6350-275-24&P

3-131. STARPIN KEYPAD OPERATION (CON'T)

To extend the closing time, a user with the required level must enter his or her PIC number followed by GO. The readout

displays the following:

SEC EXT CMD DIS

Select F2 (EXT) and quit to extend the time. The display changes from ACCESS to EXTENDED ACCESS, indicating

that the zone is now in extended time.

This procedure must be repeated each hour, or as configured, until the zone is secured.

Step 4. Securing Zone

To secure the zone, enter your PIC number followed by GO. The readout displays the following information:

SEC EXT CMD DIS

Select F1 (SEC) to secure the zone. After F1 is selected, all users must be out of the zone for the Stargate to complete

the securing process.

After the exit delay, the keypad sounds a four second tone followed by four one second beeps. When you hear this, you

know that the zone is sealed correctly.

If any non-exit sensor is operated during the exit delay, or any exit sensor is operated during the sealing process, the

zone is not sealed correctly and an alarm is sent to the master.

Step 5. Test Functions

The keypad provides both a walk test and a single sensor test. The walk test places the Stargate into a test mode to any

sensor that is declared a zone sensor. The single sensor test controls the sensor through the test feature of certain

sensors.

Only supervisor or maintenance access levels permit control of test functions.

Step 6. Walk Test

A test facility is provided to walk test any zone or 24 hour sensor. To test a sensor, the zone must be in access mode.

Follow the procedure in Step 2 above to access the zone before continuing with this sequence.

When a zone is in access, enter your PIC number followed by GO. The readout displays the following message:

SEC EXT CMD DIS

Select F4 (DIS). The LCD shows the second level soft-key options: ALM 2H MTC HST. Select F3 (MTC). This places

the keypad into the maintenance mode and provides the third level menu:

TST SNT CLR

Select F1 (TST) for the test functions. The keypad displays the third level menu:

WLK SLF ZNE SGL

3-240