REPLACE INTELLIGENT ACCESS CONTROLLER REAR PANEL ASSEMBLY

TM 5-6350-275-24&P

3-104. REPLACE INTELLIGENT ACCESS CONTROLLER REAR PANEL ASSEMBLY. (Figure 3-55).

This task consists of:

a. Remove

b. Install

INITIAL SETUP:

Tools:

General Safety Instructions:

Open End Wrench Set (Item 13, App B)

Remove all jewelry while working on

Equipment Condition:

equipment.

AC input power removed

Wear ESD wriststrap while working on

Materials/Parts:

equipment.

Intelligent Access Controller (IAC) rear panel

assembly

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables.

Failure to do so may result in serious injury or death.

a. Removal

(1) Remove front access door for IAC enclosure (8).

(2) Remove input ac power cord from power source.

(3) Remove positive and negative leads from battery (ies) (5) and remove battery (ies) from IAC enclosure (8).

(4) Tag and remove slip on terminal strips from TB1 through TB14 on IAC Printed Wiring Assembly (1).

(5) Remove four bolts (24) holding rear panel (7) to IAC enclosure (8) and remove panel assembly.

b. Installation

(1) Align rear panel assembly (7) with IAC enclosure standoffs and secure with four bolts (24).

(2) Install battery (ies) (5) in IAC enclosure and connect positive and negative leads to battery terminals.

(3) Connect tagged slip on terminal strips to TB1 through TB14.

(4) Connect ac power cord to power receptacle.

(5) Secure front access door to IAC enclosure.

3-199