REPLACE J-SIIDS GANYMEDE-B INTERFACE ASSEMBLY

TM 5-6350-275-24&P

3-94.

REPLACE J-SIIDS GANYMEDE-B INTERFACE ASSEMBLY. (See Figure 3-47).

This task consists of:

a. Remove

b. Install

INITIAL SETUP

Equipment Condition:

General Safety Instructions:

Input power removed

Remove all jewelry while working on

Enclosure access cover removed

equipment.

Wear ESD wriststrap while working on

equipment.

Materials/Parts:

J-SIIDS Ganymede Interface Assembly

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables.

Failure to do so may result in serious injury or death.

a. Replace

(1) Remove the slip-on terminal board strips from TB-1 (4), TB-2 (5), TB-6 (6) and TB-5 (2).

(2) Press in and hold latching mechanism (*) down on each plastic standoff (7), while gently lifting up on

Ganymede B PWA (1). Do this for each of the four latching mechanisms until the PWA can be removed

from enclosure (3).

(3) Place the removed Ganymede B PWA into a ESD protective bag.

b. Installation

(1) Set the link settings and/or switch settings exactly the same as on removed assembly, or refer to Appendix

E, page E-13, for PWA settings.

(2) Place the Ganymede B PWA (1) on plastic standoffs and gently press down on PWA until each of the

latching mechanism locks into place.

(3) Connect slip-on terminal strips to TB-1 (4), TB-2 (5), TB-5 (2) and TB-6 (6).(Ensure each terminal strip is

properly lined up with terminal pins)

(4) Reconnect input power.

(5) Close the front access door on enclosure (3) and secure.

3-183