REPLACE 12 VDC, 12 POINTS, EXTERIOR SUB-RADC (LEDA)

TM 5-6350-275-24&P

3-83.

REPLACE 12 VDC, 12 POINTS, EXTERIOR SUB-RADC (LEDA). (See Figure 3-44).

This task consists of:

a. Remove

b. Install

INITIAL SETUP

Equipment Condition:

General Safety Instructions:

Input power removed

Remove all jewelry while working on

Enclosure access cover removed

equipment.

Wear ESD wriststrap while working on

Tools:

equipment.

Open End Wrench, (item 14, App B)

Materials/Parts:

12 Point Exterior Sub-RADC (Leda)

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables.

Failure to do so may result in serious injury or death.

a. Removal

(1) Remove slip-on terminal strip from Leda Flex PWA TB-7 (3).

(2) Remove slip-on terminal strips (19), (18), and (17) from Leda Flex Termination PWA (1).

(3) Using an open end wrench, remove the four nuts (5) holding the Leda Panel Assembly to enclosure and

remove the Leda Panel Assembly (6).

b. Installation

(1) Align the Leda Panel Assembly (6) mounting holes up with the enclosure standoffs and secure with four

nuts (5).

(2) Connect slip-on terminal strips (19), (18) and (17) to Leda Flex Termination PWA (1).

(3) Connect slip-on terminal strip to Leda Flex PWA TB-7 (3).

(4) Reconnect input power.

(5) Replace enclosure cover and secure.

3-169