REPLACE IN-LINE FUSE - TM-5-6350-275-24-P0246

TM 5-6350-275-24&P

3-81.

REPLACE IN-LINE FUSE. (See Figure 3-43).

This task consists of:

a. Remove

b. Install

INITIAL SETUP

Equipment Condition:

General Safety Instructions:

Input power removed

Remove all jewelry while working on

Enclosure access cover removed

equipment.

Tools:

Wear ESD wriststrap while working on

Screwdriver, flat tip, (Item 6, App B)

equipment.

Materials/Parts:

Fuse, 1 AMP, 250 VAC

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables.

Failure to do so may result in serious injury or death.

a. Removal

(1) Open the In-line Fuse Holder located on input power terminal board (7).

(2) Using the flat tip screwdriver, gently lift up on fuse (8) and remove fuse from holder.

b. Installation

(1) Align fuse (8) on input power terminal fuse holder and gently press down on fuse, until fuse locks into

place.

(2) Close the In-line fuse holder.

(3) Reconnect input power.

(4) Replace enclosure cover and secure.

3-166