REPLACE TAMPER SWITCH - TM-5-6350-275-24-P0237

TM 5-6350-275-24&P

3-73.

REPLACE TAMPER SWITCH. (See Figure 3-42).

This task covers:

a. Remove

b. Install

INITIAL SETUP

Equipment Condition:

General Safety Instructions:

Input power removed

Remove all jewelry while working on

Enclosure access cover removed

equipment.

Materials/Parts:

Wear ESD wriststrap while working on

Tamper switch

equipment.

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables.

Failure to do so may result in serious injury or death.

a. Removal

(1) Tag and remove the two slip-on connectors (5) from Tamper Switch (6), by holding and pulling out on

connectors.

(2) Using a flat tip screwdriver, remove the two screws (8) and flat washers (7) holding Tamper Switch (6) to

enclosure.

(3) Remove Tamper Switch from enclosure.

b. Installation

(1)

Align Tamper Switch (6) up with enclosure mount (13) and secure with two screws (8) and flat washers (7).

(2)

Connect the tagged wires and connectors (5) to Tamper Switch (6).

(3)

Reconnect input power.

(4)

Replace enclosure cover and secure.

3-157