REPLACE TAMPER SWITCH.(Exterior)

TM 5-6350-275-24&P

3-55. REPLACE TAMPER SWITCH.(Exterior) (See Figure 3-39).

This task consists of:

a. Remove

b. Install

INITIAL SETUP

Equipment Condition:

General Safety Instructions:

Input power removed

Remove all jewelry while working

Enclosure access cover removed

on equipment.

Tools:

Wear ESD wriststrap while

Flat tip screwdriver (Item 6, App B)

working on equipment.

Materials/Parts:

Tamper switch

WARNING

Shut off power source before attempting to disconnect, service, or connect wires

or cables. Failure to do so may result in serious injury or death.

a. Replace

(1) Tag and remove the two slip-on connectors (14) from Tamper Switch (13), by holding and pulling out on

connectors.

(2) Using a flat tip screwdriver, remove the two screws (16) and flat washers (15) holding and Tamper Switch

(13) to enclosure.

(3) Remove Tamper Switch from enclosure.

b. Installation

(1) Align Tamper Switch up with enclosure mount and secure with two screws (16) and flat washers (15).

(2) Connect the tagged wires and connectors (14) to Tamper Switch (13).

(3) Connect AC adapter to power source.

(4) Replace enclosure cover and secure.

3-135