REPLACE LOG PRINTER ASSEMBLY

TM 5-6350-275-24&P

3-24. REPLACE LOG PRINTER ASSEMBLY. (Figure 3-30).

This task consists of:

a. Remove

b. Install

INITIAL SETUP:

Tools:

General Safety Instructions:

Screwdriver, Flat tip (Item 6, App B)

Remove all jewelry while working on

Materials/Parts:

equipment.

Log Printer

Equipment Condition:

Serial Interface Card removed (Para. 3-25)

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do

so may result in serious injury or death.

To avoid personal injury, use an adequate number of personnel to lift or move equipment weighing over

50 pounds or oversize equipment. Observe correct lifting techniques. Failure to do so may result in

serious injury or death.

Removal

(1) Press printer power switch (12) to off position and disconnect printer ac power cable (13) from printer (10) and

power source.

(2) Remove serial interface cable (9) from serial interface PWA connector (14) by loosening two captive screws on

serial interface cable connector, and pulling out on connector.

Installation

(1) Install Serial Interface Card.

(2) Connect serial interface cable (9) to serial interface PWA connector (14) by tightening two captive screws on

serial interface cable connector.

(3) Connect printer ac power cable (13) to printer (10) and power source.

(4) Press printer power switch (12) to on position to apply power to printer.

(5) Insure printer set-up parameters are correct. (ref. Appendix E pg.E-55)

3-96