REPLACE TAPE STREAMER MODULE

TM 5-6350-275-24&P

3-11. REPLACE TAPE STREAMER MODULE. (Figure 3-27).

INSERT SUBTITLE HERE!

This task consists of:

a. Remove

b. Install

INITIAL SETUP:

General Safety Instructions:

Equipment Condition:

Remove all jewelry while working on

PMC cabinet doors open

equipment.

Power Module AC power cord and DC power

cable removed (para 3-14)

Materials/Parts:

Tape Streamer Module

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables.

Failure to do so may result in serious injury or death.

Removal

(1) Press main power push button (1) to remove internal power to B39 processor assembly and disconnect ac power

cord from power source.

(2) Lift up on latching lever (6) on tape streamer (3) and DCX module (4) and carefully pull modular units apart.

(3) Remove tape streamer module (3).

Installation

(1) Install new tape streamer module (3) by aligning modules bus connectors and carefully push units together.

(2) When connectors are aligned and seated, lower latching lever (6). This locks modular units in place.

(3) Connect the power module (14) ac power cord (15) to power source. (ref. figure 3-26)

(4) Insert dc power cord (13) connector into rear of Tape Streamer Module. (ref. figure 3-26)

(5) Press main power push button (1) to apply internal power to processor assembly.

3-81