Table 3-4. SubRADC (Leda) With Power Supply DS Maintenance Troubleshooting

TM 5-6350-275-24&P

Table 3-4. SubRADC (Leda) With Power Supply DS Maintenance Troubleshooting

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

1. LEDA FLEX PWA FAILURE (Figure 3-4 and 3-6)

Step 1. On the Leda Flex PWA, monitor the Heartbeat LED. The LED should be flashing on and off approximately

once per second.

If the LED is flashing on and off, go to step 2.

If the lamp is not flashing on and off, go to step 4.

Step 2. Monitor the Tx and Rx LEDs on the Leda Flex PWA. The LEDs should flash on and off as data is being

transmitted to or received from the Stargate PWA.

If the Tx or Rx LED does not flash on and off, go to step 3.

Step 3. Set multimeter to read ohms and check for open wiring between the Leda Flex PWA TB7 pins 4 and 5 and

Stargate PWA AUX 0 Connector pins 2 and 6. (Place jumper wire across Stargate PWA AUX 0 Connector pins 2

and 6 )

If wiring is good, replace the Leda Flex PWA (Para. 3-63). (Remove jumper wire)

If wiring is open, replace the wire and retest.

Step 4. Set multimeter to read dc volts. Place negative lead on TB7 pin 2 and the positive lead on TB7 pin 1. The

multimeter should read +12 v.

NOTE

If there is an AC voltage line loss, an alarm will be generated

If the multimeter indication is correct, replace the Leda Flex PWA (Para. 3-63).

If dc voltage is not present, check for open wiring between the following points and replace as necessary:

FROM

Leda Flex PWA

Bridge Rectifier

TB7 pin 1

+ Positive Terminal

TB7 pin 2

- Negative Terminal on power supply TB

3-21