CHAPTER 5 ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

TM 5-6350-262-14/9

NAVELEX 0967-466-9090

TO 31S9-4-32-1

CHAPTER 5

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

Section I. TOOLS AND EQUIPMENT

8177 will normally be adequate for repair and

5-1.

Standard Tools

maintenance.

All maintenance on the Alarm and Status Modules is

performed with common tools and supplies normally

5-2.

Special Tools

used and applicable to electronic equipment. The tools

found in tool kit TK 105G, Federal Stock No. 5810-610-

There are no special tools required for maintenance of

the Status and Alarm Modules.

Section II. REPAINTING AND REFINISHING INSTRUCTIONS

vinyl paint, Federal Standard 595, color chip 26492.

5-3.

General

Use only these paints for touchup and refinishing. Refer

The front panels of the Alarm and Status Modules are

to SB11-573, Painting and Preservation Supplies

finished with a highly durable vinyl paint over an

Available for Field Use for Electronics Command

undercoat. Normally, these surfaces will not require any

Equipment.

maintenance with the exception of occasional cleaning.

However, if damage to the surface should occur, repair

5-5.

Touchup Painting Instruction

to the paint finish should be made to prevent any

Complete instructions for touchup painting and

possible corrosion or other deterioration.

repainting are contained in TB746-10, Field Instructions

for Painting and Preserving Electronics Command

5-4.

Paint to be Used

Equipment. Care of painting equipment is covered in

The front panels are primed with zinc chromate primer,

TM-9-213, Painting Instructions for Field Use.

specification number MIL-P-8585, and finished with gray

5-1