Special Information. (None)

as the last line of the description. In the Special Tools

C-4. Special Information. (None).

List, the initial basis of issue (BO1) appears as the last

line in the entry for each Special Tool, TMDE, and

C-5. How to locate Repair Parts.

support equipment.

When density of equipments

a. When Federal Stock Number or Part Number is

supported exceeds density spread indicated in the basis

Unknown:

of issue, the total authorization is increased accordingly.

(1) First. Using the table of contents, determine

g. Unit of Measure (UIM). Indicates the standard of

the assembly group within which the repair part- belongs.

the basic quantity of the listed item as used in performing

This is necessary since illustrations are prepared for

the actual maintenance function. This measure is

assembly groups and listings are divided into the same

expressed by a two-character alphabetical abbreviation

groups.

(e.g., ea, in, pr, etc. When the unit of measure differs

(2) Second. Find the illustration covering the

from the unit of issue, the lowest unit of issue that will

assembly group to which the repair part belongs.

satisfy the required units of measure will be

(3) Third.

Identify the repair part on the

requisitioned.

illustration and note the illustration figure item number of

h. Quantity Furnished With Equipment (Basic Issue

the repair part.

Items Only). Indicates the quantity of the basic issue

(4) Fourth. Using the Repair Parts Listing, find

item furnished with the equipment.

the figure and item number noted on the illustration.

i. Quantity Authorized (Items Troop Installed or

b. When Federal Stock Number or Part Number Is

Authorized Only). Indicates the quantity of the item

Known:

authorized to be used with the equipment will be

(1) First, Using the Index of Federal Stock

requisitioned.

Numbers and Part Numbers, find the pertinent Federal

j. Quantity Incorporated in Unit.

Indicates the

stock number or part number. This index is in ascending

quantity of the item used in the breakout shown on the

alpha-numeric sequence, cross-referenced to the

illustration figure, which is prepared for a functional

illustration figure number and item number.

group, subfunctional group, or an assembly.

(2) Second. After finding the figure and item

appearing in this column in lieu of a quantity indicates

number, locate the figure and item number in the repair

that no specific quantity is applicable (e.g., shims,

parts list.

spacers, etc.

C-3