National Stock Number

TM 5-6115-456-34P

Recover-

the quantity incorporated in unit column. When the part

ability

to be used differs between serial numbers of the same

Code

Definition

model, the effective serial numbers are shown as the

Reparable item. When uneconomically

last line of the description. In the Special Tools List, the

reparable, condemn and dispose at

initial basis of issue (BOI) appears as the last line in the

organizational level.

entry for each special tool.

TMDE, and support

Reparable item. When uneconomically

equipment. When density of equipment supported

reparable, condemn and dispose at the

exceeds density spread indicated in the basis of issue,

direct support level.

the total authorization is increased accordingly.

Reparable item. When uneconomically

g. Unit of Measure (U/M). Indicates the standard

reparable, condemn and dispose at the

of the basis quantity of the listed items as used in

general support level.

performing the actual maintenance function.

This

Reparable item. When beyond lower level

measure is expressed by a two character alphabetical

repair capability, return to depot.

abbreviation (e.g., ea, in, pr, etc). When the unit of

Condemnation and disposal not authorized

measure differs from the unit of issue, the lowest unit of

below depot level.

issue that will satisfy the required units of measure will

Reparable item. Repair, condemnation, and

be requisitioned.

disposal not authorized below depot/

h. Quantity Incorporated in Unit. Indicates the

specialized repair activity level.

quantity of the item used in the breakout shown on the

Item requires special handling or

illustration figure, which is prepared for a functional

condemnation procedures because of

group, subfunctional group, or an assembly. A "V"

specific reasons (i.e., precious metal

appearing in this column in lieu of a quantity indicates

content, high dollar value, critical material

that no specific quantity is applicable, (e.g., shims,

or hazardous material). Refer to

spacers, etc).

appropriate manuals/directives for specific

instructions.

Special Information.

c. National Stock Number.

Indicates the

a. Identification of the usable on codes included in

National Stock Number assigned to the item and which

the description column of this publication are:

will be used for requisitioning.

Code

Used On

d. Part Number. Indicates the primary number

Model MP 36A-60

used by the manufacturer which controls the design and

Model MP 36A-50

characteristics of the item by means of its engineering

Items not coded are applicable to all models.

drawings, specifications standards, and inspection

b. Repair parts mortality has been based on 6000

requirements to identify an item or range of items.

hours operation per year.

c. Parts which require manufacture or assembly at

NOTE

a category higher than that authorized for installation will

When a stock numbered item is

indicate in the source column the higher category.

requisitioned,

the

repair

part

d. The following publications pertain to the Power

received may have a different part

Plants and their components.

number than the part being replaced.

e. Federal Supply Code for Manufacturer

TM 5-6115-456-15

Operator, Organizational,

(FSCM). The FSCM is a 5-digit numeric code listed in

Direct and General Support

SB 708-42 which is used to identify the manufacturer,

and Depot Maintenance

distributor, or Government agency, etc.

Manual

f. Description. Indicates the Federal item name

TM 5-6115-456-20P

Organizational

and, if required, a minimum description to identify the

Maintenance Repair Parts

item. Items that are included in kits and sets are listed

and Special Tools List

below the name of the kit or set with the quantity of each

e. Repair parts kits and gasket sets appear as the

item in the kit or set indicated in

last entries in the repair parts listing for the figure