 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-6115-434-20P
SECTION I
INTRODUCTION
Code
Explanation
1. Scope
item dictates that a minimum quantity be
This manual lists repair parts and special tools required
available in the supply system.
for the performance of organizational maintenance of the
M
Applied to repair parts which are not procured or
power unit.
stocked but are to be manufactured at
indicated maintenance categories.
2. General
A
Applied to assemblies which are not procured or
This Repair Parts and Special Tools List is divided into
stocked as such but are made up of two or
the following sections:
more units, each of which carry individual
a. Prescribed Load Allowance (PLA)-Section II. A
stock numbers and descriptions and are
composite listing of the repair parts, special tools, test
procured and stocked and can be
and support equipment having quantitative allowances
assembled
by
units
at
indicated
for initial stockage at the organizational level.
maintenance categories.
X
Applied to parts and assemblies which are not
authorized for the performance of maintenance at the
procured or stocked; the mortality of which
organizational level in figure and item number sequence.
normally is below that of the applicable end
c. Special Tools, Test and Support Equipment-
item; and the failure of which should result in
retirement of the end item from the supply
equipment authorized for the performance of
system.
maintenance at the organizational level.
X1
Applied to repair parts which are not procured or
d. Federal Stock Number and Reference Number
stocked, the requirement for which will be
supplied by use of the next higher assembly
ascending numerical sequence followed by a list of
or component.
reference numbers in ascending alpha-numeric
X2
Applied to repair parts which are not stocked.
sequence, cross-referenced to the illustration figure
The
indicated
maintenance
category
number and item number.
requiring such repair parts will attempt to
obtain them through cannibalization; if not
3. Explanation of Columns
obtainable through cannibalization, such
repair parts will be requisitioned with
The following provides an explanation of columns in the
supporting justification through normal
tabular lists in sections II, III, and IV:
supply channels.
a. Source, Maintenance, and Recoverability Codes
C
Applied to repair parts authorized for local
(SMR):
procurement. If not obtainable from local
Note
procurement, such repair parts will be
Common hardware items known to be readily
requisitioned
through
normal
supply
available in Army supply channels are
channels with a supporting statement of
assigned Maintenance codes only. Source
nonavailability from local procurement.
codes,
Recoverability
codes,
and
G
Applied to major assemblies that are procured
Maintenance Allowances are not assigned
with PEMA (Procurement Equipment Missile
this category
.
Army) funds for initial issue only to be used
(1) Source code, indicates the selection status
as exchange assemblies at DSU and GSU
and source for the listed item. Source codes are:
maintenance level. These assemblies will
not be stocked above DSU and GSU level or
Code
Explanation
returned to depot supply level.
P
Applied to repair parts which are stocked in or
(2) Maintenance code, indicates the lowest
supplied from DSA/GSA or Army supply
category of maintenance authorized to install the listed
system, and authorized for use at indicated
item. The maintenance level code is:
maintenance categories.
P2
Applied to repair parts which are procured and
Code
Explanation
stocked for insurance purposes because the
O
Organizational maintenance
combat or military essentiality of the end
iii
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals