NOTES - TM-5-5420-212-10-20032

NOTES:

a Put BSB on RB.

b. Add Bay 1 and put BP under 1p7.

c. Fit nose roller.

d Add Bay 2 and put BP under 2p6.

e Add Bay 3 (with headless pin) and put BP at 3p7.

f. Add LNCG posts, LNCG, nose roller and LLN

g Place BSB to side of site near rear of bridge

h Remove nose sections as they pass LRP, observing 5 ft (1.5 m)

minimum overhang. Leave last three nose sections in place until

far bank end of bridge has been lowered to ground

i. Launch until far bank end of bridge is 9 in (23 cm) from LRP or

BSB overhangs RB by 1.5 ft (0.5 m) If minimum bearing is being

used, launch to center hole in BSB

j. Lower LRP, remove last 3 LNH

k. Put Bridge on the ground

^ Position LRP 9 in (23 cm) from F peg.

[ ] Counterweight. (Counterweight BSB connected by shootbolts

only)

( ) Center of gravity.

* Add LRP and secure with tie down strap.

** Bridge will tip as nose is boomed

2-7