Difference in Models - TM-5-5420-205-140018

TM 5-5420-205-14

Figure FO-7. Electro-hydraulic functional schematic, superstructure

model nos. 2195-1 and 2195-2, raise and lower.

(Located in back of manual)

Figure FO-8. Electro. hydraulic functional schematic, interior bay

model no. 2195-1 superstructure, curbing up and down.

(Located in back of manual)

Figure FO-9. Electro-hydraulic functional schematic, interior bay

superstructure, model no. 2195-2, curbing up and down.

(Located in back of manual)

Figure FO-10. Hydraulic functional schematic, interior girder pinning,

superstructure, model no. 2272.

(Located in back of manual)

Figure FO-11. Hydraulic functional schematic, superstructure rotation,

model nos. 2271 and 2272.

(Located in back of manual)

Figure FO-12. Hydraulic functional schematic, ramp fold and unfold,

superstructure model no. 2271.

(Located in back of manual)

Figure FO-13. Hydraulic functional schematic, end bay girder pinning,

superstructure model no. 2271,

(Located in back of manual)

Figure FO-14. Hydraulic functional schematic, raise and lower,

superstructure model nos. 2271 and 22 72.

(Located in back of manual)

Figure FO-15. Hydraulic functional schematic, interior bay curbing

up and down, superstructure model no. 2272.

(Located in back of manual)

Figure FO-16. Hydraulic functional schematic, end bay curbing up

and down, superstructure model no. 2271.

(Located in back of manual)

curb sections and hydraulic cylinders used for actuation of

1-9. Difference in Models

the section.

This manual covers the CONDEC (Consolidated Diesel

b. Hydraulic Systems. Superstructure models no. 2271

Electric Company) interior bay superstructure, model no.

and 2272 contain additional pilot controlled check valves.

2195-1 (S / N 0001 through 0057) and model no. 2272 (S/N

Check valve E7387 is located in interior bay model no.

0001 through 0122); end bay superstructures, model 2195-2

2272, and check valve E2640 is located in end bay model

(S/N 0001 through 0029) and models 2271 (S/N 0001

no. 2271. Other differences between superstructure

through 0062). The differences between interior bay and

hydraulic systems are comprised of cylinder diameters,

end bay superstructure models are noted in the appropriate

hose length and routing, tube length and routing, and

paragraphs throughout the manual. The following briefly

fittings.

describes the differences between superstructure models.

c. Electrical Systems. Interior bay model no. 2272

a. Curbing. Table 1-1 specifies the number of

contains a terminal board in the electrical

1-6