DD Form 1750 (Packing List) and DD Form 1348-1 (DOD Single Line Item Release Document).

TM 43-0156

(6)

POE/APOE: Coded and in the clear.

(7)

POD/APOD: Coded and in the clear.

(8)

Consignee: Coded and in the clear.

(9)

Piece number.

(10)

Total pieces.

(11)

Weight: Gross weight of each piece, container, MILVAN etc.

(12)

Cube: Each piece.

d. Palletized Unit Loads. Provided that a smooth surface is available, apply the address to the lower one-

third of an identification-marked surface of the load (fig. E-9). If the load does not provide a smooth surface,

place the label on a weather-resistant panel or place a tag on any suitable space of an identification marked

surface.

e. Unpacked Vehicles. Place the address on the rear or the right side near the rear of the vehicle. Apply

it to a weather-resistant, 1/4-inch plywood panel, or secure it with PPP-T-60 tape directly on the vehicle

surface.

f. SEAVAN/MILVAN. The address for SEAVANs/MILVANs shall be on DD Form 1387-1 attached to the

seal or at the rear of the van. Shipping containers, palletized unit loads, and unpacked items consolidated into

a full van load by the origin shipper for delivery as a unit to the ultimate consignee do not require address

marking.

E-7. DD Form 1750 (Packing List) and DD Form 1348-1 (DOD Single Line Item Release Document).

a. Packing List. For containers or unitized loads packed with unlike items, or a single stock numbered

item comprised of unlike items, where full description of the contents is not authorized or cannot be shown on

the container, prepare separate packing lists, as required for each box or container. Place one copy of the list

loose inside of the container on top of the contents, and place a second copy in a water-resistant envelope and

securely attach to the outside of the container in the most protected location. Foroversea shipments, further

protect the packing list with an envelope protector marked with the words "Packing List." Exterior containers

holding unlike items identified by a single stock number, in addition to the item description on each packed item

in the container, shall include packing lists listing each of the items in the container. When a single stock

numbered set, kit, or assembly is packed in more than one shipping container, in addition to the packing list for

each container, furnish a master packing list which can be made of duplicates of each of the individual lists or

the master may be a compiled correlated listing. Packing lists shall not be affixed to the outside of containers

holding classified items.

E-11