Radiator Fan Belts. - TM-43-01560205

TM 43-0156

Step

Function

Mech

Insp

3 Atomize spray 4 ounces of preservative oil

cont

(9150-00-111-0209) into the open port. Do not

exceed 25 psi.

4 Repeat the preservative cycle until all cylinders

have been atomize sprayed with preservative oil.

5 Atomize spray the interior of each air box with

preservative oil (9150-00-111-0209).

6 Replace air box covers and close cylinder test

valves. Check seals in covers for proper position.

(e) Top Deck. Atomize spray all parts under the

engine top deck covers with preservative oil

(f) Radiator Fan Belts.

1 Remove the fan belts.

2 Coat unpainted surfaces of pulley grooves with

3 Install fan belts but do not tighten.

4 Prepare tag (8135-00-292-2345) to indicate

"RADIATOR FAN BELT TENSION RELIEVED - ADJUST

PRIOR TO STARTING ENGINE."

5 Attach the tag to the engine control panel.

(g) Generator.

1 Coat flywheel gear and pinion gear of starter with

2 Remove ventilation grills.

3 Raise the brushes and place a strip of barrier

(8135-00-226-3124) between them and the slip rings.

4 Seal the ventilation grills with barrier (8135-00-

282-0565) and tape (7510-00-916-9659). Tape 7510-

00-890-9875 may be used as a substitute.

5 Prepare tag (8135-00-292-2345) to indicate "BAR-

RIER HAS BEEN PLACED INSIDE THE GENERATOR

BETWEEN THE BRUSHES AND THE SLIP RINGS.

GENERATOR VENTILATION GRILLS HAVE BEEN

SEALED. REMOVE BEFORE OPERATION."

Change 1

B-3-52