Generator.

TM 43-0156

Step

Function

Mech

Insp

4 Prepare a UU-T-81 tag to indicate "RADIATOR

cont

FAN BELT TENSION RELIEVED - ADJUST PRIOR TO

STARTING ENGINE."

5 Attach the tag to the engine control panel.

(g) Generator.

1 Coat flywheel gear and pinion gear of starter with

MIL-G-10924 grease.

2 Remove ventilation grills.

3 Raise the brushes and place a strip of MIL-B-121

barrier between them and the slip rings.

4 Seal the ventilation grills with MIL-B-131 barrier

and MIL-T-22085 tape. PPP-T-60, type 4, 4-inch

wide tape may be used as a substitute.

5 Prepare a UU-T-81 tag to indicate "BARRIER HAS

BEEN PLACED INSIDE THE GENERATOR BETWEEN

THE BRUSHES AND THE SLIP RINGS. GENERATOR

VENTILATION GRILLS HAVE BEEN SEALED. REMOVE

BEFORE OPERATION."

(h) Engine Air Filters.

1 Drain oil.

2 Remove filter elements and atomize spray interior

of air filter with MIL-L-21260, type I, grade 30

3 Install filter elements and seal intake opening

used as a substitute.

4 Attach a UU-T-81 tag to the engine control panel

indicating "ENGINE AIR FILTERS DRAINED."

(1)

Outside Air Intake Filters (sides).

1 Open filter retainers.

2 Remove fiberglass filter element.

3 Remove wire grate.

4 Cover an NN-P-530, 5/16-inch plywood panel (78 x

16-1/2) with MIL-B-131 barrier and place over fil-

ter openings. NN-P-530; 3/8-inch plywood may be

used as a substitute.

Change 1

B-3-6