Packing for the Silencers, Elbows, Gaskets, and Exhaust Supports for the 2000 KW.

TM 43-0156

Step

Function

Mech

Insp

(5)

Place gaskets in a PPP-B-636 fiberboard box (15-1/2

cont.

x 15-1/2 x 2) and seal box lid with PPP-T-76 tape.

Secure to upright panel which supports the elbows

with QQ-S-781 steel strapping, edge protector and

seals.

(6)

Place the "Y" braces and bars of the exhaust support

in the top cradle and secure with FF-N-836 nuts.

(7)

Install blocking and bracing. Refer to figure B-2-8

for fabrication and location details.

(8)

Place crate top over base and secure with FF-W-92

washer and FF-B-561 lag bolts (1/2 x 4).

(9)

Mark container in accordance with appendix E and the

following: Mark all four sides of the container

with 2-inch minimum size letters to indicate

"REUSABLE CONTAINER - DO NOT DESTROY."

Packing for the Silencers, Elbows, Gaskets, and Exhaust

Supports for the 2000 KW.

(1)

Fabricate a MIL-C-104 crate (133-1/2 x 109-1/4 x

51-1/2) and cradles in accordance with appendix D-3

and figure B-2-9. Refer to table B-2-11 for a list

of materials.

(2)

Secure flat piece of the exhaust support to the base

with FF-W-82 flat washer and FF-t-836 nuts.

(3)

Place silencers into cradle and secure with FF-N-836

nuts.

(4)

Bolt elbows to base and upright panels with FF-B-584

bolts (1/2 x 4).

(5)

Place gaskets in a PPP-B-636 fiberboard box (15-1/2

x 15-1/2 x 2). Seal box lid with PPP-T-76 tape.

Secure to upright panels which support the elbows

with QQ-S-781 steel strapping, edge protectors, and

seals.

(6)

Place bars of the exhaust support and the "Y" braces

in the top cradle and secure with FF-W-92 washer and

FF-N-92 nuts.

(7)

Install blocking and bracing. Refer to figure B-2-9

for fabrication and location details.

B-2-46