Engine Openings

TM 43-0156

Step

Function

Mech

Insp

(c)

Secure bag to the inside wall of the engine control

cont

panel using MIL-T-22085 tape. PPP-T-60, type 4,

4-inch wide tape, may be used as a substitute.

(d)

Prepare a UU-T-81 tag indicating "BATTERIES RE-

MOVED FROM TACHOMETER POWER UNIT AND

STORED INSIDE ENGINE CONTROL PANEL."

(e)

Secure tag to the engine control panel.

(f)

Coat electrical contacts and terminals with

MIL-C-83360 coating compound.

(g)

Place PPP-C-1797 cushioning on the face of control

panel and secure with MIL-T-22085 tape. PPP-T-60,

type 4, 4-inch wide tape, may be used as a substitute.

(h)

Place PPP-F-320 fiberboard over PPP-C-1797

cushioning and secure with MIL-T-22085 tape.

PPP-T-60, type 4, 4-inch wide tape, may be used as

a substitute.

(16) Engine Openings. Seal the following with MIL-C-5501

caps or plugs, or with MIL-T-22085 tape (PPP-T-60

tape may be used):

(a)

Crankcase breathers.

(b)

Dipsticks (two).

(17) Depreservation Guide.

(a)

Complete two DA Forms 2258 for the power plant.

(b)

Place one copy In a MIL-B-117 bag and heat seal.

(c)

Secure the guide to the control panel.

(d)

Place the other copy in the logbook.

(18) Warning Tag.

(a)

Prepare a UU-T-81 tag indicating "DEPROCESS

ENGINE IN ACCORDANCE WITH DA FORM 2258

(Attached to this equipment) - IN ADDITION, THE

AIR CLEANERS, FILL PORTS, EXHAUST STACK,

BREATHER TUBES, FUEL TANK VENT HOLE,

AND BATTERY FILLER OPENINGS HAVE BEEN

SEALED - REMOVE SEALS PRIOR TO CRANKING

ENGINE."

(b) Secure the tag to the engine control panel.

b. Packing for the Diesel Generator (three for 1500 KW,

four for 2000 KW).

Change 1

B-2-8