Depreservation Guide. - TM-43-01560045

TM 43-0156

Step

Function

Mech

Insp

CAUTION

Ensure floor mounting holes

cont

are drilled behind the fuel tanks.

(3)

Radiator. Brace radiator to the floor with

QQ-S-741, 3-inch angle iron. Secure braces at 45

angle from approximately two-thirds up on the

radiator to the floor. Drill and tap a hole in the

floor for a FF-B-583 bolt (3/8 x 1) and FF-W-92 flat

washer.

(4)

Control Panel Door. Brace door with MM-L-751 lumber

(72 x 2 x 4) to prevent opening during shipment.

(5)

Lifting Dollies (two). Secure lifting dollies to

the lifting beams with Q,-W-461 wire.

Depreservation Guide.

(1)

Complete two DA Forms 2258 for the generator set and

air compressor if applicable.

(2)

Place one copy into a MIL-B-117 bag and heat seal or

staple.

(3)

Mark bag to indicate contents and secure to engine

control panel.

(4)

Place the other copy in the logbook.

Logbook.

(1)

Place the logbook. and one set of keys into a

MIL-B-117 plastic bag and heat seal or staple.

(2)

Mark bag to indicate contents and secure to the

control cabinet with MIL-T-22085 tape. PPP-T-60,

type 4, 4-inch wide tape, may be used as a sub-

stitute.

Access Doors.

(1)

Coat the rubber door seals with MIL-S-8660 silicone.

(2)

Tape inside of window with MIL-T-22085 tape. PPP-T

60, type 4, 4-inch wide tape, may be used as a substitute.

(3)

Cover outside of windows with MIL-B-131 barrier

and NN-P-530, 5/15-inch plywood pan l (21 1/2 x 21).

NN-P-530, 3/8-inch plywood may be used as a substi-

tute. Secure with MIL-T-22085 tape. PPP-T-60, type

4, 4-inch wide tape, may be used as a substitute.

Change 1 B-1-14