Click here to make tpub.com your Home Page

Page Title: Anchoring of butt boards.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 38-400/NAVSUP PUB 572/AFMAN 23-210 MCO 4450.14/DLAM 4145.12
inches of height plus the slope of the lumber bed. For
or other soft wood is substituted for oak. The angle on
example, suppose the slope of the foundation on which
the butt boards is designed to give a forward pitch to
the lumber will be placed is 11/2 inches in each 12
each draft of 1%/8 inches to each 12 inches in height.
inches of length. The slope forward on the butt board
Since the slope of the stack foundations from front to
will then be 11/2 inches plus fiveeights of an inch in
rear is 1 inch for each 12 inches of length, this provides
each 12 inches of height of the butt board. This equals
five-eighths of an inch pitch per foot in height in the
21/8 inches forward slope or pitch of the butt board in
completed stack. Should the slope of the lumber beds
each 12 inches of height. For each 10 feet of height
vary from 1 inch of slope in 12 inches of length, an
from the bottom of the first draft, the stack will project
adjustment to correct the pitch can be made easily by
forward 61/4 inches at the top beyond the end of the
starting with a line perpendicular to the ground, then
bottom board.
giving a forward pitch of five-eighths of an inch to each
12
Figure 5-4. Diagram of butt boards used to control pitch on draft face.
by-4 is sometimes placed across the base flush against
(2) Anchoring of butt boards.
Once the
and parallel to the face of the butt board. In this way,
position of each butt board is established, it should be
the front end of the draft should just clear the forward
anchored firmly. This can be done by driving iron rods
straddle carry truck bolster so that a portion of the
into the ground at points where pressure will be exerted
weight of the front end of the draft rests on the 2-by-4. It
or by nailing pieces of 2-inch stock to the butt board,
is essential that each butt board remain in exactly the
extending these pieces to the platform, and nailing the
same position
pieces securely to the platform. To assist in stabilizing
the butt board, a 2-
5-5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business