Riveting Removal and Replacement.

TM 32-6110-003-24&P

NOTE

It may be necessary to remove the RFI filter assembly (6) in order to obtain access

to attaching parts for front panel. (Refer to paragraph 5-10c, steps (1) through (4).)

(2) Remove MISSION POWER switch S1 (13) in accordance with paragraph 5-12a.

(3) Remove circuit breakers (18) in accordance with paragraph 5-12b.

(4) Remove lampholder XDSI (40) in accordance with paragraph 5-12p.

(5) Remove handles (51) in accordance with paragraph 5-12q.

(6) Using thin-walled socket tool TMD-16 and 1/4 inch drive wrench remove 14 nuts (52), lock washers

(53), and flat washers (54) from stud (65) on rear of front panel (16) and remove front panel (16)

from chassis.

(7) To replace front panel (16), place front panel (16) on chassis and using thin-walled socket tool TMD-

16 and 1/4 inch drive wrench, thread 14 nuts (52), lock washers (53), and flat washers (54) on stud

(65) at rear of panel.

(8) Install handles (51) on front panel (16) in accordance with paragraph 5-12q.

(9) Install lampholder XDSI (40) on front panel (16) in accordance with paragraph 5-12p.

(10) Install circuit breakers (18) on front panel (16) in accordance with paragraph 5-12b.

(11) Install MISSION POWER switch SI (13) in accordance with paragraph 5-12a.

(12) Replace top cover (2) and bottom cover (3) in accordance with paragraph 5-11c.

(13) Refer to section V of this chapter.

s. Riveting Removal and Replacement. To replace a rivet(s) on the chassis or on an item of hardware,

proceed as follows:

(1) Remove covers and components as required to gain access to rivet(s) to be replaced. (Refer to

(2) Center punch the head of rivet(s) to be replaced.

(3) Using a drill smaller than the diameter of the rivet, drill out the center of rivet head to be replaced.

5-33