Chapter 5. ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

TM 32-5895-227-14&P

CHAPTER 5

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

Section I. TOOLS AND EQUIPMENT

5-3 MATERIALS . Materials required are listed in

5-1 TOOLS AND TEST EQUIPMENT . Tools and test

Appendix F of this manual. There are no special

equipment required are listed in Appendix D of this

materials required.

manual. There are no special tools or test equipment

required.

5-2 REPAIR PARTS. Repair parts required are listed

and illustrated in Appendix E of this manual.

Section II. REPAINTING AND REFINISHING INSTRUCTIONS

Preserving Electronics Command Equipment Including

CAUTION

Camouflage Pattern Painting of Electrical Equipment

Do not paint nameplates, panel

Shelters. Paints and finishes will be in accordance with

nomenclature, plastic surfaces, or

SB 11-573, Painting and Preservation Supplies

electrical switches and contacts.

Available for Field Use for Electronics Command

Equipment, and in accordance with AR 746-1,

5-4 REPAINTING,

REFINISHING,

AND

Packaging of Army Materiel for Shipment and Storage.

RETOUCHING . Repainting, refinishing, and retouching

of the AN/MSQ-71 will be accomplished-in accordance

with TB 43-0118, Field Instructions for Painting and

Section III. LUBRICATION INSTRUCTIONS

AN/MSQ-71.

Refer to TM 11-5815-206-12

for

5-5

GENERAL. There is no lubrication order for the

lubrication of Teletypewriter Set AN/TGC-14.

Section IV. PREVENTIVE MAINTENANCE CHECKS AND SERVICES

71 not ready (Red) for its primary mission in column

5-6 SCOPE.

Organizational

preventive

five.

Footnotes are added to indicate special

maintenance checks and services (PMCS) are

requirements when unusual conditions exist.

performed weekly, monthly, and quarterly as authorized

b. Records and reports will be in accordance with

by the Maintenance Allocation Chart (MAC). These

TM 38-750.

periodic checks and services help maintain the

c. All organizational PMCS will be performed at

AN/MSQ-71 in operating condition. Defects that cannot

initial installation and when the equipment is reinstalled

be corrected will be reported to direct support

after removal.

maintenance.

a. Table 5-1 lists the inspection sequence in

column one, the inspection interval in column two, the

item to be inspected in column three, the procedure in

column four, and the reasons for reporting the AN/MSQ-

5-1