Maintenance Code. - TM-9-2350-259-24P0010

TM 9-2350-259-24P

Code

Explanation

Items with these codes are not to be requested/

requisitioned individually. They must be made from

bulk material which is identified by the part

number in the DESCRIPTION AND USABLE ON CODE (UOC)

column and listed in the Bulk Material group of the

repair parts list in this RPSTL. If the item is

authorized to you by the 3d position code of the

SMR code, but the source code indicates it is made

at a higher level, order the item from the higher

level of maintenance.

Items with these codes are not to be requested/

requisitioned individually. The parts that make up

the assembled item must be requisitioned or fabri-

cated and assembled at the level of maintenance

indicated by the source code. If the 3d position

code of the SMR code authorizes YOU to replace the

item, but the source code indicates the items is

assembled at a higher level, order the item from

the higher level of maintenance.

X A - Do not requisition an "XA"-coded item. Order its next higher assembly.

(Also, refer to the NOTE below.)

XB - If an "XB" item is not available from salvage, order it using the FSCM

and part number given.

XC - Installation drawing, diagram, instruction sheet, field service drawing,

that is identified by manufacturer's part number.

X D - Item is not stocked. Order an "XD"-coded item through normal supply

channels using the FSCM and part number given, if no NSN is available.

NOTE: Cannibalization or controlled exchange, when authorized, may be used as

a source of supply for items with the above source codes, except for those

source coded "XA" or those aircraft support Items restricted by requirements

of AR 700-42.

(2) Maintenance Code. Maintenance codes tell you the level(s) of

maintenance authorized to USE and REPAIR support items, The maintenance codes

are entered in the third and fourth positions of the SMR Code as follows: