Quantcast Removal - TM-9-2350-238-20-20312

 

Click here to make tpub.com your Home Page

Page Title: Removal
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
lNSPECTION/REPAIR - TM-9-2350-238-20-20311
Up
TM-9-2350-238-20-2 Crane (CAB) Components Recovery Vehicle Full-Tracked: Light Armored M578 (
Next
INSPECTION/REPAIR - TM-9-2350-238-20-20313
TM
9-2350-238-20-2
2-83. MAINTENANCE OF RIGHT AND LEFT LEVEL WIND SOLENOID TO SENSING
SWITCH AND RECTIFIER ELECTRICAL LEAD ASSEMBLIES (CONT).
Make sure MASTER switch is
OFF before repairing electrical
components. Failure to observe
this warning could result in in-
jury
to
personnel.
Failure
to
remove
or
disconnect
the batteries before removing or
installing
any
electrical
wiring
harness or lead may result in in-
jury
or
damaged
equipment.
NOTE
Electrical lead tag numbers ap-
pear
more
than
once.
Traverse
turret
90
degrees
to
the left for ease of removal/in-
stallation  of  wiring  harness.
The following removal steps are
written  and  illustrated  for  the
right  level  wind  solenoid  to
sensing switch and rectifier
electrical  lead  assembly  but  also
apply to left level wind solenoid
to  sensing  switch  and  rectifier
electrical  lead  assembly.
1 Disconnect  electrical  lead  480  (1)  from
right  level  wind  sensing  switch  (2).
2 Remove
all
necessary
clamps,
fasteners,
and grommets from level wind solenoid to
sensing  switch  and  rectifier  electrical  lead
assembly (3).
3 Disconnect  electrical
lead
480
(4)
from
rectifier (5).

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.