There may be shims between the
b o o m e y e s and cylinder eyes. If
reinstalling old shims, they must be
in the same position.
4 Using hammer and drift, install two upper
hinge headless straight pins (6).
5 Install lubrication fitting (7)
headless straight pin (6).
6 Install two nut and pin boom hinge pin
locking plates (8), two new Iockwashers
(9), and two hexagon capscrews (10)
securing two upper hinge headless
7 Remove sling from hoist. Remove sling
from crane boom (1).
Make sure MASTER switch is OFF
before repairing electrical circuits.
Failure to observe this warning could
result in injury to personnel.