 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM
9-2350-238-20-2
2-10.
ELECTRICAL
CIRCUIT
TROUBLESHOOTING
(CONT).
Make
sure
MASTER
switch
is
OFF
before
repairing
electrical
com-
ponents. Failure to observe this warning could result in injury to
personnel.
Step 2. Disconnect lead 47 (1) from slip ring (2). Place red probe in lead 47.
Ground black probe. Set MASTER switch ON. If multimeter indicates about
24 volts, go to step 3. If multimeter indicates no voltage, repair lead 47
between hull well disconnect (3) and slip ring, refer to page 2-66. Set
MASTER switch OFF. Connect lead.
Step 3. Disconnect GND lead (1) from slip ring (2). Place red probe on GND lead.
Ground
black
probe.
If
multimeter
indicates
go
to
step
4.
If
multimeter
indicates
infinity,
repair
GND
lead,
refer
to
Connect
lead.
2-32
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals