INSTALLATION (Cont) - TM-9-2350-238-20-11105

TM 9-2350-238-20-1

5 Position lower half of butt hinge (13) and windshield pivot retaining spring (1) on driver's base

assembly (12), aline holes, and secure with two machine screws (14), flat washer (15), and two

new self-locking nuts (16).

6 Align holes in upper (2) and lower (13) halves of butt hinge, and secure by installing chain

assembly (17) and new cotter pin (18).

7 Position lower half of butt hinge (19) and windshield pivot retaining spring (6) on driver's base

assembly (12), align holes, and secure with two machine screws (20), flat washer (21), and two

new self-locking nuts (22).

8 Align holes in upper (8) and lower (19) halves of butt hinge, and secure by installing chain

assembly (23) and new cotter pin (24).

NOTE

Steps 9 and 10 are written for one window strap plate, but apply to both window strap

plates.

9 Install flat washer (25), new lockwasher (26), hexagon plain nut (27), and machine screw (28)

through window strap plate (29), and secure with flat washer (30) and hexagon plain nut (31).

10 Install window strap plate (29), two new Iockwashers (32), and two machine screws (33).

11 Position top edge of driver's base assembly (12) on top edge of driver's cupola opening (34),

and secure with two flat washers (35) and two machine screws (36). Grind or trim pads to

position drive base assembly on driver's cupola opening.

NOTE

Step 12 is written for installation of one chain plate link, but applies to both chain plate

links.

12 Install chain plate link (37), flat washer (38), and machine screw (39) on driver's base assembly

(12).

13 Position vehicular window (40) on driver's base assembly (12). Latch three fasteners (41), and

connect driver's cupola chain (42) to chain plate link (37) on both sides of vehicular window.

14 Install webbing strap (43) on rear of vehicular window (40).

15 Connect vehicular safety belt (44) to machine screw (28) on each side of vehicular window (40).

If necessary, adjust distance between vehicular safety belt (44) and machine screw (28) as

follows:

a. Loosen hexagon plain nut (27).

b. Adjust machine screw (28) in or out until snap on vehicular safety belt (44) fastens over

head of machine screw.

c. Adjust position of machine screw (28) in slot of chain plate link (29) to secure vehicular

window (40) to driver's cupola opening (34).

d. Tighten hexagon plain nut (27).

16 Install two toggle switches (45 and 46) and four machine screws (47).

2-1079