Removal of Battery Positive Terminal to Circuit Breaker Electrical Leads

TM 9-2350-238-20-1

Failure to remove or disconnect batteries before removing or installing any electrical

lead or wiring harness may result in injury or damage to equipment.

NOTE

Tag all electrical leads during removal to aid in installation.

1 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. Remove only the hardware which secures the harness or lead being

removed.

2 Tag and disconnect battery positive terminal to circuit breaker electrical lead (1) from battery

positive terminal (2).

3 Remove battery positive terminal to circuit breaker electrical lead (1) from coolant heater circuit

breaker (3).

4 Tag and disconnect battery positive terminal to circuit breaker electrical lead (4) from battery

positive terminal (5).

5 Remove battery positive terminal to circuit breaker electrical lead (4) from circuit breaker (6).

2-1041