 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2350-238-20-1
4 Electrical wire is a manufactured item,
1 Inspect for broken, damaged, or missing
refer to appendix D.
parts.
5 Repair is by replacement of authorized
2 If damaged or missing, replace marker
parts (TM 9-2350-238-24P-1).
bands. Etch or stamp lead number on
new band.
3 For repair of shell connectors and cable
terminals, refer to page 2-371.
1
Install warning light low coolant detector to
bulkhead disconnect branched wiring
harness (1) on powerplant.
Untag and connect cable terminal (2) to
2
ground.
Untag and connect three cable terminals
3
(3) to aeration detector.
4
Install aeration detector cover (4) and two
screws (5).
Untag and connect shell connector (6) to
5
diode assembly and transmission
temperature warning switch.
Untag and connect two shell connectors
6
(7) to line disconnects to warning light.
Wiring harnesses and leads are secured
7
to the engine with loop clamps, straps,
ground screws, etc. During installation,
make sure the wiring harness or lead is
secure and all hardware is tight.
2-729
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals