SERVICE HEADLAMP, TAILLIGHT, AND STOPLIGHT CIRCUIT. (cont)

TM 9-2350-238-20-1

Step 1.

Set MASTER switch ON. Turn vehicular light switch to SER DRIVE. If both

taillight and service headlamps are off, go to step 2. If both service

headlamps are on and taillight is off, go to step 6. If taillight is on and both

service headlamps are off, go to step 10.

Step 2.

Set MASTER switch OFF. Disconnect connector from vehicular light switch.

Place red probe in socket F of receptacle. Ground black probe, If

multimeter indicates about 24 volts, replace vehicular light switch. Refer to

page 2-566. If multimeter indicates no voltage, go to step 3. Connect

connector to vehicular light switch.

2-207