GENERATOR CHARGING CIRCUIT. (Cont) - TM-9-2350-238-20-10167

TM 9-2350-238-20-1

Make sure MASTER switch is OFF before repairing

electrical circuits. Failure to observe this warning

could result in injury to personnel.

Step 3.

Place red probe in socket (+) of slave receptacle. Place black probe in

socket (-) of slave receptacle. Set MASTER switch ON. If multimeter

indicates about 24 volts, go to step 4. If multimeter indicates no voltage,

repair lead 49 between slave receptacle and voltage regulator. Refer to

page 2-371. Set MASTER switch OFF.

Make sure MASTER switch is OFF before repairing

electrical circuits. Failure to observe this warning

could result in injury to personnel.

Step 4.

To access bulkhead disconnect, remove driver's seat, refer to page 2-952;

and remove driver's compartment aft cowl, refer to page 2-928. Discon-

nect wiring harness at bulkhead disconnect. Place red probe in socket

(lead 2). Ground black probe. Set MASTER switch ON. If multimeter

indicates about 24 volts, go to step 5. If multimeter indicates no voltage,

repair lead 2 between bulkhead disconnect and generator-regulator. Refer

to page 2-371. Set MASTER switch OFF. Connect wiring harness at

bulkhead disconnect.

2-141