 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-202-14&P
4-29.
CHASSIS WIRING HARNESS REPLACEMENT (continued).
6.
At front road-side corner of frame, remove nut (17), screw (18), and lockwasher (19) from loop clamp (20) and
frame. Discard lockwasher.
7.
Remove chassis wiring harness (13) from frame. Remove 11 loop clamps (16) and loop clamp (20) from chassis
wiring harness (13).
b.
INSTALLATION
1.
Position chassis wiring harness (13) along rear crossmember, road-side frame, and road-side drawbar (5). Make
sure chassis wiring harness connectors (6 and 9) reach their points of connection. 2.At front road-side corner of
frame, install loop clamp (20) on frame with new lockwasher (19), screw (18), and nut (17).
NOTE
The M116A2E1 and the M116A3 have no lockwashers at loop clamp mountings on rear crossmember
and road-side frame. A lockwasher is used at loop clamp mounting on road-side drawbar.
3.
Install 11 loop clamps (16) securing chassis wiring harness (13) to rear crossmember, road-side frame, and road-
side drawbar (5) with 11 new lockwashers (15) and screws (14).
4.
Loop excess chassis wiring harness (13) and secure with new electrical tiedown straps (12).
5.
At curb-side and road-side rear of trailer, connect chassis wiring harness connectors (9) to light connectors (10).
Place connectors (9 and 10) in clips (11).
6.
At junction box (4) at road-side drawbar (5), connect chassis wiring harness connectors (6) to intervehicular cable
connectors (7). Place connectors (6 and 7) in clips (8).
7.
Install cover (3) on road-side drawbar (5) with four new lockwashers (2) and screws (1).
FOLLOW-ON TASKS:
Connect intervehicular cable to towing vehicle (para 2-13).
4-45
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals