 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-202-14&P
4-28.2. STOPLIGHT MAINTENANCE (M101A1 AND M116A1) (CONTINUED).
4.
Touch up paint (refer to TM 43-0139).
5.
Inspect lens retainer for signs of moisture leakage, cracks, warpage, and damaged screwdriver slots
or threads on screws. Inspect lenses for cracks or breaks. Replace lens retainer if lens retainer or
lenses are damaged.
6.
Inspect housing for cracks and dents. Replace housing if damaged.
7.
Inspect grommet for damage. Inspect retaining plate for cracks and distortion. Inspect socket and
wiring assembly for good electrical and mechanical connections, cracked or bad insulation, broken
wires, corroded sockets or terminals, and cracked isolators. Replace socket and wiring assembly,
retaining plate, and grommet as an assembly if grommet, retaining plate, or socket and wiring
assembly is damaged.
e.
STOPLIGHT ASSEMBLY
1.
Slip wires through hole in housing (27).
2.
Position grommet (26), retaining plate (25), and socket and wiring assembly (24) inside housing (27)
with double socket at top. Install three screws (23).
3.
Install two new lockwashers (22) and screws (21).
4.
Install lamp (6) in top-left socket (7) and lamp (6) in bottom socket (7) by pushing in and turning
clockwise.
5.
Install lamp (5) in top-right socket (7) by pushing in and turning clockwise.
6.
Slip three shells (19) over electrical contacts and wires. Install three slotted washers (20) in back of
electrical contacts and pull shells over slotted washers and electrical contacts.
Change 2 4-42.9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals