 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
(12) Install jumper cable (24) on battery posts
(25 and 26).
(13) Tighten two nuts (27) on jumper cable
(24). Torque to 84-96 lb-in. (9.4-10.8
Nm).
(14) Lightly coat battery posts (25 and 26) with
grease.
(15) Insert negative (-) cable (28) through
rubber grommet (4).
(16) Insert wire no. 1435 (29) and wire no.
1373 (30) through rubber grommet (4).
(17) Insert positive (+) cable (31) through
rubber grommet (4).
(18) Install wire no. 1435 (29), wire no. 1373
(30), and negative (-) cable (28) through
lower hole (33) in battery box (5).
(19) Install positive (+) cable (31) through
upper hole (34) in battery box (5).
(20) Install wire no. 1435 (29) and negative (-)
cable (28) to cable clamp (35) with screw
(36), washer (37), new lockwasher (38),
and nut (39). Torque to 144-192 lb-in.
(16.1-21.5 Nm).
(21) Install wire no. 1373 (30) and positive (+)
cable (31) to cable clamp (40) with screw
(41), washer (42), new lockwasher (43),
and nut (44). Torque to 144-192 lb-in.
(16.1-21.5 Nm).
c. Follow-On Maintenance
(1) Connect arctic kit batteries (para 19-2).
(2) Start engine (TM 9-2320-360-10).
(3) Check
battery
operation
(TM
9-2320-360-10).
(4) Shut off engine (TM 9-2320-360-10).
Change 1 19-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
