 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
NOTE
Align matchmarks on end of rear
shaft and inside of yoke.
(4) Install yoke (5) on rear shaft (2).
NOTE
Concave side of washer faces out.
(5) Install washer (6), new lockwasher (7),
and screw (8) on rear shaft (2). Torque to
55 lb-ft (75 Nm).
(6) Coat inside of caps (9 and 10) with
grease.
CAUTION
Bearing caps must be installed so
that universal joint pivots freely in
yoke. Failure to comply will result in
premature universal joint failure.
(7) Install cap (9) in yoke (11).
(8) Install universal joint (12) in yoke (11).
(9) Install cap(10) in yoke (11).
WARNING
Wear eye protection and use care
when installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
(10) Install two retaining rings (13) in yoke (11).
17-47
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
