 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
11-4.1. SLACK ADJUSTER (AUTOMATIC - AXLE NO. 1) REPLACEMENT (CONT)
CAUTION
There must be at least 0.5 in. (12.7
mm) of clevis thread engagement
with the push rod. Also, the push rod
must not extend thru the clevis more
than 0.125 in. (3.18 mm). Failure to
comply may result in damage to
equipment.
NOTE
Do steps (5) and (6) only if small hole
in clevis is not completely visible
thru template.
(5) Loosen jamnut (7). Rotate the clevis (3)
clockwise if small hole is below clevis or
counter-clockwise if small hole is above
clevis.
(6) Repeat steps (3) and (4) to verify
adjustment. Tighten jamnut (7).
(7) Remove large clevis pin (1) from clevis
(3).
11-10.4 Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
